Steel Bushey Navy Tug 100' Commercial Seagoing Workboat
Newer Caterpillar Engine
Steel Bushey Navy Tug 100' Commercial Seagoing Workboat for sale | 100'0" | 1944 | 1x diesel 1100hp | Steel Construction | Full-Displacement underwater profile | 5 sleeping berths | Boat REF# 220164
|Engine||1 x diesel 1100hp, Caterpillar D 399 (1989)|
|Lying||Puget Sound, WA, USA - Shown by Appointment|
Contact the Broker
- Contact Dave Carleson
- Telephone +1 206 282 0110
- Cell +1 206 979 4433
- Email firstname.lastname@example.org
|Builder||Ira S. Bushey and sons, Brooklyn, NY|
Puget Sound, WA, USA - Shown by Appointment
Get quote for boat deliveries
|Fuel capacity||21,000.0 USG Total - 3 Tanks|
|Water capacity||5,700.0 USG Total - 2 Tanks|
|Engine||1 x diesel 1100hp|
|Engine make and model||Caterpillar D 399 (1989)|
|Engine Hours||engine1: 1225|
|Prop(s)||Four blade S.S. 80/60|
|Fuel consumption (approx)||14.0 USG /hour At Cruising Speed|
|Cruising speed (approx)||10 knots|
|Max speed (approx)||12.5 knots|
The rated hours before re-build of the upper end is about 10,000 hours and this engine has 1,225 hours after that rebuild. The rated hours for the lower end re-build is every 20,000 hours so that re-build has not yet taken place. The seller has a complete spare second engine (Cat D 399) which is available for an additional $75,000.
The main engine is air start. There are two air compressors both 10 hp. One is a Quincy 325 and the other is Ingersol Rand.
12 volt, 4 batteries charged by: generator There are three diesel powered generators.
There is no holding tank because this boat has a MSD Micro-Phor overboard system.
This 100' Steel Coastal Tug was built for the navy and is designated YTB 387. It is of the Bushey design as specified for the Navy. It was built in 1944 but went into storage in Bremerton WA until going into service in 1974.
Waterline Boats / Boatshed does not independently verify dimensions and capacities, which are reported from literature and/or seller's information.
|Total # of berths||5|
|No. of double berths||1|
|No. of single berths||3|
|Heads||1 heads (Vac flush)|
|Manual water system|
|Pressurised water system|
|Hot water system|
|Fresh water wash|
|Raw water wash|
This is a working tug in every respect. It is currently working moving a log barge in BC. It has a long and successful history of service including open ocean coastal travel. The pilot house has modern electronics and controls as well as a private double cabin for the captain. There is a passageway down to the galley dining saloon. This area is equipped with two full-size refrigerators. One operates on 120 volts and the other on 12 volts. There is a large galley table with ample seating for the crew. It is a great "off watch " area. There is a pantry aft and to the port with a passage way to the engine room. Also there are door ways port and starboard to the side decks.
4 burner electric Stove
|VHF DSC radio|
Stingray NASA Depth Sounder (new)
Sea C157 VHF Radio with DSC
Standard Horizon VHF without DSC
Uniden LTD 715 VHF "
Sea 156 VHF "
Icom IC-M700 Single Side Band
Sperry Auto Pilot
JRC JHS 182 DSC Ship ID Interfaced with GPS
Furuno Radar 1932 Mark ll
Furuno Radar FR 7062
Weems and Plath Clock and Tide Clock
Built in AM FM Radio
Fire Kidde Fire Alarm system with three location sensors.
There are two on-deck helm stations.
Mckiernan-Terry windlass (with remote control)
450'0" of chain
Livingston dinghy (unknown year)
450 feet of 3/4" chain
|Carbon Monoxide detector|
4 bilge pumps (0 manual / 1 electric)
There are three gas driven pumps for emergency fire or dewatering the bilge. Also there is a fire alarm for three areas of the boat, two sensors are in the engine room and one in the galley.